Nano Screw Terminal Adapter datasheet specifies incorrect board dimensions

[barriault]

Arduino Nano screw terminal adapter board dimensions on data sheet (section 3.1) are wrong. You specify a 70 mm board width, and also 4 mm to edge of each mounting hole plus 63 mm between holes. 63 + 4 + 4 = 71, not 70.

[jcarolinares]

Hello @barriault thank you so much for opening the issue and helping us to detect this problem.

It was already addressed in the pull request #2372 (review) and will be available in a new version of the datasheet during the next hours, again thank you so much for the opening issue!