Skip to content

SD Stuff

Jump to bottom Edit New page
luni64 edited this page Apr 26, 2020 · 1 revision

SD Connectors

T3.X

TBD

SD Connector for Teensy 4

  • HFW8R-1STE1LF
  • SFW8R-2STE1LF
    Fits the solder pad layout on the teensy 4 but the lock tabs are a little too wide to fit between the header pins if used. The tabs are only plastic though and can be trimmed with a sharp knife/scalpel (see post)

It is expected that a Teensy 4.1 will be released that uses a Teensy 3.5/3.6 form factor and will include a micro-SD card reader.

Alternatives for bringing out the SD card pins on the Teensy 4.0.

Teensy is a PJRC trademark. Notes here are for reference and will typically refer to the ARM variants unless noted.

Home

Basics
Connectivity
PC Communication
Displays
Timing, delays and clocks
Audio & MIDI
Libraries
Compiling, Languages & Uploading
Debugging
Electronics
Fun stuff
HowTo's

FAQ

Clone this wiki locally